2-component anchoring material, styrene and solvent free, polyester base.
- Fast ripening
- Applies with standard hand cartridge gun
- It is used at low temperatures
Compressive strength: ~60 N/mm2 (7 days, +20 °C) (ASTM D 695)
Modulus of elasticity in compression: ~3 500 N/mm2 (7 days, +20 °C) (ASTM D 695)
Tensile bending strength: ~28 N/mm2 (7 days, +20 °C) (ASTM D 790)
Tensile strength: ~12 N/mm2 (7 days, +20 °C) (ASTM D 638)
Operating temperature:
- Long term -40 °C minimum / +50 °C maximum
- Short-term (1-2 hours) +80 °C
Uses
- Rapid curing anchoring adhesive for fixing to:
- Bars / rebars
- Threaded anchor bolts (strings)
- Screws and special fastening systems
- Concrete
- Masonry with solid and perforated bricks
- Hard natural rock*
- Solid rock*
* These substrates may vary significantly, mainly in terms of their strength, composition and porosity. Therefore, in each application on these substrates the suitability of Sika AnchorFix®-1 must be confirmed by applying it to a test area. Mainly check adhesion strength, surface staining and discoloration potential.
Advantages
- Fast ripening
- Applies with standard hand cartridge gun
- It is used at low temperatures
- High load carrying capacity
- Approved according to ETA for anchorages in non-cracked concrete
- Approved according to ETA for solid and hollow masonry
- It does not slip even in ceiling applications
- Styrene free
- Light smell
- Reduced material loss